Voodoo Lab

Hi John: I've been doing some checking around and the issue is definitely with the M13. Seems Line 6's response is the M13 is not designed to be a MIDI controller and that the MIDI Out is for backing up patches, etc. With that they have no intention of addressing any latency. I also confirmed that y...

Hello All: I have the Line 6 M13 and the VooDoo Lab Control Switcher to use the MIDI from the M13 to change the change the channel on my Marshall DSL40C. The problem is I'm getting about a 1/2 second delay when I change scenes & channels on the M13 and this is likely a deal breaker for me as I don't...

Thank you, John, for your prompt reply - I greatly appreciate it! When the new amp arrives later this week I'm going to play it straight up for a few days to make sure it's all good. I'll then add the M13 and Control Switcher back in the mix and I suspect I'll be good to go. Good to know about the f...

Adding to my post above... I noticed that on some of the Youtube Videos showing the Control Switcher that when they press buttons 1 & 4 to save the configuration all four lights flash at the same time. When I press buttons 1 & 4 to save on my device, lights 1 & 3 and 2 & 4 alternately flash - not al...

Hello Forum: This past Saturday I received a new Marshall DSL40C, Line 6 M13 and VooDoo Lab Control Switcher so the M13 can change channels/reverb on the amp. Played the amp w/the M13 Saturday and no issues. Even at loud volumes the amp was relatively quiet. Saturday night I setup the Control Switch...