Voodoo Lab

Can I have my tc delay and tc reverb rackunit, already connected in loops of the GXC, used as IA on the GCP? I.e. I wanna have the guitars dry signal (fx off) on number 1 and then be able to add-in delays of reverbs by selecting them as IA’s. I would suggest to configure AI buttons to ask for the s...

I'm having trouble getting #3 & #4 to work. I reset it so you have to turn on/off each pedal because I use different combos of amps. #1 and #2 work fine. But 3 &4 have almost no volume. If I switch cables around, then AMPs 3 and 4 work fine plugged into 1 & 2, but then AMPs 1 and 2 (now plugged int...

Welcome to the board... You can use the GCPro to control multiple amps and I suspect the best starting point for you would be to take a look at the 13 sample worksheets on the GXC product page to see which one most closely resembles what you want to do and go from there. Once you determine that, co...

Welcome to the board, Steve! As per the Pin Out diagram for the MS100's 8-Pin DIN foot switch connector, Pin 8 controls the Channel Switching so I suspect you are correct about using Momentary (pulse) mode to effect a channel change. Besides the obvious audible tonal differences between the two cha...

A guitar signal and a MIDI signal are two totally different things; it doesn't matter where you plug in your guitar, MIDI will always work. What you've written doesn't describe how you're currently using your GCX or how you've connected your G-Major2, so more info on that would be good. In the mean...

Could I still use a second Boss CE-2? Also what patch cables need to be stereo? Does the Y cable need to be? Instead of adding a second CE-2, you might want to consider replacing your existing CE-2 with a stereo unit such as the CE-5 or the CE-2W, etc. That way you're only swapping out the pedal an...

The other I went to play with my rig and got this ## on gcp and now it won't work with midi I can power it up with power supply but get nothing with midi When it's powered up with a power supply, does it still control your GCX and/or other MIDI devices? First trouble-shooting step would be to swap ...

Based on what you wrote, your noise isn't coming from your GCX or GCPro, but is obviously being generated by whatever Overdrive pedal you're using, as you've already proved taking it out of your signal chain eliminates the noise. Given that, you could try substituting a different OD pedal to see if...

My apologies. I completely overlooked the issue of converting your signal from Mono to Stereo after the TS-9, and as already mentioned, the Palmer Y-Box is not the right tool for that job. Instead, you'll need to run the last device of your Mono signal chain into a Stereo device of some sort to con...