MXR M-108 Equalizer

[deepblue]

Im thinking of the MXR 10 band Eq. (M-108) I believe they are 18v
So, I just need to buy the coupler cable and run 2/9v outlets.
Is this correct?....which 2 outlets would be best?

Thank you.

[JohnClark]

Any two outputs of a Pedal Power 2+ set to Normal will work with the 18V Y cable to power the M-108 or any of the 18V MXR pedals. Good Luck!

[ddubrule]

Hi! I have a problem with my PP2+ and my MXR m108 10-band EQ

I have the Y cable for a 18V pedal but my EQ doesn't work. It functionned once at my home while I was testing it, but not at my practice place. I don't remember if my pedalboard was full set at home.

The Y cable are in the 2nd and 3rd slots (starting from left) of my PP2+. I will try other slots tonight.

All other slots are occupied by a pedal of 9V (tuner, comp, boost, OD, distortion, Tremolo). I also have one (TC Electronic stereo chorus/flanger) in the plug of my PP2+ Is it possible that it's too much asking for the PP2+ ?

Thank you for your time.

Daniel

[JulianShur]

That should be fine. Which cable are you specifically using? You should be using the PPY cable: http://www.voodoolab.com/shop/index.php ... 3g5h5pbga0

As John said, any of the 9V outputs should be fine to combine (9+9=18V, and it doesn't need much current).

Hope that helps.

[ddubrule]

It helps a lot! I have the one with the orange tip. I understand that is not the good one.