Page 1 of 1
ISO 5 & VL Ground Control Pro
Posted: Wed Jan 27, 2010 2:05 pm
by Jeremy
This was hinted at on the HRI Forum last year when the ISO 5 was still in development (then the high output was 500mA). Can the ISO 5 power the GCPro with the high output 9V @ 300mA?
Thanks!
Re: ISO 5 & VL Ground Control Pro
Posted: Thu Jan 28, 2010 1:17 pm
by JohnClark
The High Current 9V output on the ISO-5 can be used to power a Ground Control Pro.
Re: ISO 5 & VL Ground Control Pro
Posted: Mon Jun 21, 2010 10:39 am
by Jeremy
Hey John,
To bump this old question, if I use the High Output 9VDC on the ISO 5, do I have to use a reverse polarity cable? Or can I use a standard cable?
Re: ISO 5 & VL Ground Control Pro
Posted: Tue Jun 22, 2010 11:34 am
by JohnClark
For this you would use the Red ended barrel cable so it fits the 2.5mm power jack on the Ground Control Pro. Good Luck!
Re: ISO 5 & VL Ground Control Pro
Posted: Thu Jul 01, 2010 7:48 am
by arizona guitarist
JohnClark wrote:The High Current 9V output on the ISO-5 can be used to power a Ground Control Pro.
...and phantom power a Pedal Switcher? But I would probably be more interested in the PP2+.
Re: ISO 5 & VL Ground Control Pro
Posted: Thu Jul 01, 2010 10:26 am
by JohnClark
The Pedal Switcher does not accept phantom power.
Re: ISO 5 & VL Ground Control Pro
Posted: Thu Jul 01, 2010 6:09 pm
by arizona guitarist
JohnClark wrote:The Pedal Switcher does not accept phantom power.
Sorry, the other way around...can it power the Pedal Switcher and still let the Pedal Switcher power the Ground Control?
Re: ISO 5 & VL Ground Control Pro
Posted: Fri Jul 02, 2010 9:50 am
by JohnClark
arizona guitarist wrote:JohnClark wrote:The Pedal Switcher does not accept phantom power.
Sorry, the other way around...can it power the Pedal Switcher and still let the Pedal Switcher power the Ground Control?
I'm going to have to say no to this one. The current load would likely be too much for reliable operation. Also, the Pedal Switcher should get 12V when using DC power. Good luck!