PP2+ Eventide TF, Boss RC30, TC Electronics, BB pre, Foxrox
Posted: Sun Mar 11, 2012 3:02 pm
I have had a Pedal Power 2 Plus a long time now. I'm still happy
I just recently noticed an update in the PP2+ manual that now recommends using a Current Doubling Adapter in outputs 5 and 6 with their DIP switches set AWAY from NORMAL with the red reverse polarity cable to safely power the Eventide Timefactor.
This was not in the manual that came with my PP2+ so I hope it is still ok to power my TF this way?
Basically, will my PP2+ work ok powering this board?
Outlet 1 - TC polytune (current draw 50 mA @ 9vDC)
Outlet 2+3 with current doubling adapter - Boss RC30 looper (current draw 195 mA @ 9vDC - usually uses a PSA series AC Adaptor)
Outlet 4 - Xotic BB preamp (current draw 6 mA @ 9vDC)
Outlet 5+6 with current doubling adapter - Eventide TF
Outlet 7 - Foxrox Hot Silicon fuzz (low current draw @ 9vDC)
Courtesy AC outlet - TC SCF stereo chorus flanger using a reverse IEC connector.
Thanks!
I just recently noticed an update in the PP2+ manual that now recommends using a Current Doubling Adapter in outputs 5 and 6 with their DIP switches set AWAY from NORMAL with the red reverse polarity cable to safely power the Eventide Timefactor.
This was not in the manual that came with my PP2+ so I hope it is still ok to power my TF this way?
Basically, will my PP2+ work ok powering this board?
Outlet 1 - TC polytune (current draw 50 mA @ 9vDC)
Outlet 2+3 with current doubling adapter - Boss RC30 looper (current draw 195 mA @ 9vDC - usually uses a PSA series AC Adaptor)
Outlet 4 - Xotic BB preamp (current draw 6 mA @ 9vDC)
Outlet 5+6 with current doubling adapter - Eventide TF
Outlet 7 - Foxrox Hot Silicon fuzz (low current draw @ 9vDC)
Courtesy AC outlet - TC SCF stereo chorus flanger using a reverse IEC connector.
Thanks!