Pedal Power 2 with micro Pog issues.
Posted: Mon Sep 24, 2012 3:47 pm
Hi,
I was successfully running the Micro Pog from outlet 4 but now this strange thing happens...after playing for about 30 minute my Pog starts to make this crackling sound which then turns into a feedback sound. I've swapped out the connector and I thought that was it but it happened again yesterday. When I isolate the Pog > straight into the amp, it works!
Does anyone know if this could be faulty outlet on a power pedal 2?
Do these symptoms sound familiar?
For now I've put the Pog into 6 (my last free outlet) and so far it hasn't done it...yet.
Cheers,
S
My mistake....again!! The micro pog requires 200mA...despite successfully running it from outlet 4 for 5 months....though I thought this would just cause some unintentional sag (which it didn't seem too).
Could I have damaged the PP2 in any way by running 200mA in outlet 4?
cheers,
S
I was successfully running the Micro Pog from outlet 4 but now this strange thing happens...after playing for about 30 minute my Pog starts to make this crackling sound which then turns into a feedback sound. I've swapped out the connector and I thought that was it but it happened again yesterday. When I isolate the Pog > straight into the amp, it works!
Does anyone know if this could be faulty outlet on a power pedal 2?
Do these symptoms sound familiar?
For now I've put the Pog into 6 (my last free outlet) and so far it hasn't done it...yet.
Cheers,
S
My mistake....again!! The micro pog requires 200mA...despite successfully running it from outlet 4 for 5 months....though I thought this would just cause some unintentional sag (which it didn't seem too).
Could I have damaged the PP2 in any way by running 200mA in outlet 4?
cheers,
S