Amp Selector Output..Not Good

[dkbarnwell]

Hello All,

I have an Amp Selector and have been using it for a couple of years now, just fine. The pots on it were always a little scratchy but I tend to leave them at their level so that wasn't a problem. Now, the outputs are starting to sound really bad. I would describe it as making my amps(s) sound like they have a blown speaker. I have tried plugging straight in the front of my amps and sounds as it should. I have eliminated all other pedals and any cables from the issue. I'm kinda stuck here as my rig consists of three Marshall heads.

Any suggestions?

Thanks in advance,

Derek

[JohnClark]

How are you powering the Amp Selector?

[dkbarnwell]

Hey John,

With a Pedal Power2. It powers all my devices and has for about two years. This problem has creeped in fairly recently. I'll tell ya something I tried late last night was removing the outer shell and blasting the unit with contact cleaner. I can't report back on the success of that, It was late and I wasn't going to run out my Marshalls at midnight but I will try it out tonight and let you know.

In the mean time, if you can give some thought, I would appreciate it.

Thanks,
Derek

[JohnClark]

Well it sounds like we should take a look at this one. Give us a call or write to info@voodoolab.com so we can discuss your repair options.