Page 1 of 1
Daisy Chain with Pedal Power 2 Plus?
Posted: Mon Aug 03, 2009 1:22 pm
by Universe326
Hi, is it possible to run a daisy chain off a Boss TU2 tuner when it is being powered by the PP2P? I have tried this so far it seems not to work. Any suggestions?
Re: Daisy Chain with Pedal Power 2 Plus?
Posted: Tue Aug 04, 2009 12:08 pm
by JohnClark
Not sure what you tried to power but it should at least work for one or two low current pedals. Remember that the Pedal Power 2+ outputs are limited to either 100 or 250mA depending on the output used. Add up the current demand of each pedal and the tuner to find out if you are under the max. It is also possible that there is a ground lift happening which would require that all the audio cables are connected before all the pedals would power up.