Voodoo Lab

Hi there. I’m new on this forum and I do my best in english, from France...be easy with me so!
I’m planning to buy a Dingbat Px but I’m not sure if my configuration will fit this Px8 switching system.

I have 2 amps plus 4 effects front pedals (disto-booster-preamp-fuzz) (called F1-F2-F3-F4 for explanations) which goes to a ABY box / direct to Amp A / for the Amp B, I got 3 modulations pedals (M1M2M3) which goes in the Fx Amp B Loop.

Current settings:
F1F2F3F4 ——ABY——> A direct to Amp A
——> Send Fx Amp B to
M1M2M3 to Fx Return
Amp B

I’d like to manage the 7 pedals with the Px 8 of the Dingbat Px.

The question is: if I leave the Loop 5 of Px always on, can I go out from « send of loop 5 » to ABY pedal /one jack to Amp A, orher to input Amp B, have « fx loop send Amp B » to « return loop 5 Px8 », and final « outpout Px8 » to return « Fx loop Amp B »? Would that work properly?

When I read back my post, looks horrible...Really apologize for that but looking for competent and expert people to fix it.

Hope to read from you!

Thanks a lot!
Merci!
Rock On!
Bonne journée!

Romain « stutch »

Your suggested setup may work, but I cannot guarantee it would be noise free since it would be likely to have ground loop problems.

Also, your written English is perfectly understandable

Oh, thank you thank you for the answer.
I guess there’s no other set up possible to achieve my needs with this configuration?

I heard a little about ground loop...when you say « it is likely », that means a 50/50% chance to have hum?

My ABY is a radial bigshot, hope that’ll keep Away ground loops.

I think i’ll order it, try, and give feedback here to share experience.
If there’s any orher solution, let me know.

Thanks again, merci!

Romain

Hi there Romain! How did it work? I just bought the px8 and I run my amps in wet/dry... same as you but with a Lehle dual as the ABY box.
Thanks

Hi Chico.
Everything works perfectly well for me; Was a bit not confident but I fo not have any ground loop or something.
Just had a little buzz at first, but that was due to « old fashioned circuit » from a British Pedal Company ToneBender 2. Move it more ahead in the signal (before loop 1) and it ‘s ok.
Have the ABY on loop 4, which is always on, amp-effect-loop return back to px8 loop 4, and I’m a convinced happy user of Voodoo Lab Px8!
What about your configuration?
Hope it helps.
Merci!
Hope it helps.