help with triaxis/gcx

[Bro]

i am just setting up my triaxis with my gcx and not sure the proper way of doing it.
I have a Triaxis,MXR kfk-1 eq,rocktron xpression,boss ds-1 going into a mesa 2:100.
I can set it up ok with my gcp.Just alittle confused with the loop path setup.
All i know for sure is i would like to keep the eq in the effects loop of the triaixs.

[Bro]

and i will have the xpression changing with the triaxis.
only coming on when i turn the loops on.

[JohnClark]

Where do you want to route the Xpression? If in the effects loop (probably best) do you run it before or after the EQ?

[Bro]

after the eq.
I leave the eq on all the time(in my effects loop).I want to switch the xpression on and off in the loops.I have the xpression changing patches with the triaxis,and want to only turn the xpression loops on for the patches i use effects on.
But then again i am open to any suggestions you have to make it work.

[JohnClark]

The GCX routing would be quite easy in this case. The Effect Send from the Triaxis goes to the EQ. The EQ would go to the Input of a GCX loop. The Send and Return of that GCX loop would go to the In and Out of the Xpression respectively. The Output of the GCX loop would go to the Effects Return of the Triaxis. Let us know how you do!