gcx/gcp and egnater tourmaster

[levinyinon]

i made the cable thet we need 1/4 jack..
i need to program the gcp???
what i need to do to cange chanel on my egnater?

[levinyinon]

???

[levinyinon]

pleas help

[levinyinon]

someone??

[JohnClark]

Wow

If you have the cable made correctly and connected to the amp and the GCX, then all that is left is to turn GCX loops on and off as needed.
First you will need to enable the GCX within the Ground Control Pro if you have not done this already. This is found in the Expanders section of the Ground Control Pro manual under Setup Mode.
Enabling Ground Control Pro Instant Access buttons that control the GCX loops directly is covered in the Select Preset section of the Ground Control Pro manual.
Creating Ground Control Pro presets that set the state of GCX loops is covered in the Controlling the GCX section of the Ground Control Pro manual under Edit Preset.
In short, yes, you will need to program the Ground Control Pro. Let us know if you have any specific questions if you get stuck. Good Luck