I Need to Program Instant Access buttons 2-5 HELP!

[dkbarnwell]

Hey Folks,

I need to program my ground Control Pro instant access buttons #2-#5 to send midi CC messages as with instant access button #1. The manual only illustrates how to program button #1 and I can't seem to get to instant access button #2. When I try to access button #2, using the Bank Down button and it puts into the GCX loops mode.

It would seem that I could use instant access button #2-#8 for something else other than loops. My end goal is to be able to use instant access #2-#4 to switch channels on three Marshall heads individually and then set up Instant access button #5 to switch all on/off three together. I am using a RJM Amp Gizmo.

If anybody has any insights, I would be most appreciative of your help.

Derek

BTW: I have set up instant access button #1 bypass the effects on my two TC Electronic GMajors and that works pretty well.....

[jgastineau]

Hey Folks,

I need to program my ground Control Pro instant access buttons #2-#5 to send midi CC messages as with instant access button #1. The manual only illustrates how to program button #1 and I can't seem to get to instant access button #2. When I try to access button #2, using the Bank Down button and it puts into the GCX loops mode.

1. Press Bank Down
2. Press +/Yes repeatedly until it gets past GCX to controllers
3. Use < & > -/+ buttons to set midi channel, controller, and mode (keep going right)

Jeff