JohnClark wrote:I was referring to the software within the Ground Control Pro. The current version is 1.13. The new v2 software will be a EProm chip that gets replaced inside the Ground Control Pro.
The Sense Electronics program is an editor/librarian that a Ground Control Pro user created.
I hope that helps!
I'm new to this hardware - so I'm just curious. How often are there firmware updates and is that considered user-serviceable? I mean, do we order a new EEPROM or do we have to bring the GCP to an authorized dealer, etc? Just curious.
And also - I was hoping to confirm, is that Sense program what everyone uses? Is that the best windows-based editor for the CGP or is there anything else available? Just curious - thanks!
JohnClark wrote:...with the current Ground Control Pro software...
What is this??
I didn't see any downloads on the Voodoo website, but I did stumble across a little utility on http://www.sense-electronics.nl/ - is that what you mean, or is there some better utility for editing the GCP? (btw, I'm using an Eleven Rack too, and am interesting in making the integration a little less manual)
Thanks!
I was referring to the software within the Ground Control Pro. The current version is 1.13. The new v2 software will be a EProm chip that gets replaced inside the Ground Control Pro.
The Sense Electronics program is an editor/librarian that a Ground Control Pro user created.
I hope that helps!
When exactly is this new firmware going to be made available?
