GCX + long cable runs = another buffer somewhere?

[rp108]

Ok, I haven't tested anything yet, cables are on the way. But with all my pedals I am looking at well over a 100ft of cable.

With my pedalboard, I have about 30ft of cable before I hit the GCX buffer. Then, I have 8.5 ft of cable for each loop so that's 68 ft of cable!

The first 4 loops will be in front of the amp, so another 10 ft cable from the GCX to the amp. Then the remaining 4 loops will go to the send/return of the amps loop. Another 12ft total.

This is a lot of cable!

Should I add another buffer in the chain somewhere?

Thanks!

[JohnClark]

What is on your pedalboard? That would be the most likely place to run an external buffer, if you indeed needed one.

[rp108]

The pedal board is simple. Guitar -> 10ft cable -> tuner -> 6" patch -> wah pedal -> 15ft cable -> GCX buffer. These pedals are true bypass.

I may add a volume pedal at some point.