GCX + long cable runs = another buffer somewhere?
Posted: Thu Oct 20, 2011 7:06 am
Ok, I haven't tested anything yet, cables are on the way. But with all my pedals I am looking at well over a 100ft of cable.
With my pedalboard, I have about 30ft of cable before I hit the GCX buffer. Then, I have 8.5 ft of cable for each loop so that's 68 ft of cable!
The first 4 loops will be in front of the amp, so another 10 ft cable from the GCX to the amp. Then the remaining 4 loops will go to the send/return of the amps loop. Another 12ft total.
This is a lot of cable!
Should I add another buffer in the chain somewhere?
Thanks!
With my pedalboard, I have about 30ft of cable before I hit the GCX buffer. Then, I have 8.5 ft of cable for each loop so that's 68 ft of cable!
The first 4 loops will be in front of the amp, so another 10 ft cable from the GCX to the amp. Then the remaining 4 loops will go to the send/return of the amps loop. Another 12ft total.
This is a lot of cable!
Should I add another buffer in the chain somewhere?
Thanks!