Page 1 of 1
Transmit a MIDI CC with Program Change?
Posted: Tue Nov 22, 2011 7:20 am
by borehead
I am wondering if you could transmit a MIDI CC aswell when you do a Program Change on the GCP?
All I know is that I can program IA-buttons to perform CC:s.
Regards,
Johan, Sweden
Re: Transmit a MIDI CC with Program Change?
Posted: Tue Nov 22, 2011 9:54 am
by mboogman
I think if you set the IA button to transmit with preset, it would do this. It's somewhere in the manual about how to do that.
Re: Transmit a MIDI CC with Program Change?
Posted: Thu Nov 24, 2011 11:55 am
by borehead
Yes, that I know. Do you know if there's some way to do it without the IA-button? Because that is what I want to do.
Re: Transmit a MIDI CC with Program Change?
Posted: Thu Nov 24, 2011 6:14 pm
by mboogman
I don't think that's possible. Pretty sure you can only do program changes.
Re: Transmit a MIDI CC with Program Change?
Posted: Wed Apr 04, 2012 2:49 pm
by FallenAudio
It's not possible with GCP.
My solution was to add Midisolution Inc, Event Processor (plus)
to the midi-chain.
You can change pc-messages to cc-messages and other way around and much more.
In my case, I use it to change IA-buttons cc-message to pc-message that loads Eventide TimeFactors preset.
It also maps the cc-value to a certain cc-number to turn preset on/off.
http://www.midisolutions.com/prodepp.htm