GCP/GCX whammy and exp. pedal issue
Posted: Thu Mar 05, 2015 12:45 pm
I have a Digitech Whammy into loop 1 of my GCX. It works fine when I step on the IA 1 button to activate it.
I have an expression pedal (from a mammoth electronics kit) with a stereo output. I used this as a volume pedal for my G System and it worked fine. Never an issue.
I connected the pedal with a TRS cable (same one I used with the G) in pedal 1 on the GCP and it recognizes it. When I move the pedal the numbers change on the GCP and the active light flickers on the GCX. I have the whammy set up as the correct device number and it works just fine.
I can't get the expression pedal to work at all. I changed the ctrl number to 11, which is what the whammy manual says on page 12 (Using MIDI continuous control commands, the Whammy’s Expression Pedal position can be remotely controlled. MIDI CC11 adjusts the Expression Pedal position. A value of 0 on MIDI CC11 corresponds to a toe up position and a value of 127 corresponds to a toe down position) to set it at. As far as I know I set everything up correctly but not having any luck.
Any suggestions on things I may have missed?
Thanks.
I have an expression pedal (from a mammoth electronics kit) with a stereo output. I used this as a volume pedal for my G System and it worked fine. Never an issue.
I connected the pedal with a TRS cable (same one I used with the G) in pedal 1 on the GCP and it recognizes it. When I move the pedal the numbers change on the GCP and the active light flickers on the GCX. I have the whammy set up as the correct device number and it works just fine.
I can't get the expression pedal to work at all. I changed the ctrl number to 11, which is what the whammy manual says on page 12 (Using MIDI continuous control commands, the Whammy’s Expression Pedal position can be remotely controlled. MIDI CC11 adjusts the Expression Pedal position. A value of 0 on MIDI CC11 corresponds to a toe up position and a value of 127 corresponds to a toe down position) to set it at. As far as I know I set everything up correctly but not having any luck.
Any suggestions on things I may have missed?
Thanks.