Voodoo Lab

Hi - I have the 3 Line 6 Pro units - the mod, filter and echo. I have two GCX's and the Controller to manage these rack units as well as the following pedals. I am trying to split into 2 amps:

Pedals
To LEAD AMP (#1)
Boss DD2
MXR P-90
Homebrew Detox EQ
Xotic RC Boost
Fulltone Soul Bender

To RHY/CLEAN (#2)
Ethos Overdrive
Ibanez TS 808
Way Huge Aqua Puss
Boss DD3
Line 6 Echo Pro
Line 6 Filter Pro
Line 6 Mod Pro
(WILL MIDI ALLOW 1 LOOP FOR ALL 3 EFFECTS?)

Since I am splitting into two distinct paths, what is best way to wire the Line 6 modules?

Many, many thanks and Happy Holidays!

You can put as many devices in a single loop as you wish. Is the amp split a strict A/B switch or do you run both at the same time?

Hi -

Merry Christmas to you and thanks for the response. Ideally, each effect would have it's own loop so I can trigger them on/off as needed. Amps would be wired so only one is one at any given time.

Thanks!

The effects would connect to the GCX loops wired in series as is most common. The amps would be connected as per Example 2 in the GCX manual under A/B Switching. There are quite a few rig diagrams that contain these elements and more at http://www.voodoolab.com/gcx.htm. Good luck!