Just purchased a zoom G3 and pedal power 2 plus

[lunchbox239]

I just want to verify before i place the order, the only way to power the zoom g3 off the pedal power 2 plus is with a current doubling cable correct?

[JulianShur]

To power your Zoom G2 use a current doubler adapter (part# PPAP) in Pedal Power 2 Plus outputs 5 and 6, DIP switches set NORMAL with one of the all black (standard polarity) cables supplied.

So yes, you are correct

[shredmiyagi]

As an added question..

I also have a Zoom G3 (need to buy a current doubler... oops I was using a voltage doubler, hope I didn't do damage to anything after hour or so of use!)... I assume it needs 5 & 6 to get the 500mA of juice.

I'd like to also power my Whammy 5 pedal with the PP2+. From what I understand it needs about 280mA 9v. Is this possible with the 5/6 outputs taken? Can I use 3 of the 100mA slots with a custom current tripler cable?

I only need to power a Suhr Riot (100mA) and maybe my compressor after that, so running out of outputs isn't an issue.

[JulianShur]

The voltage doubler cable with your G3 may have damaged the pedal, maybe make sure it still works by using the supplied power adapter if you have it.

The Whammy 5 probably needs a current doubler cable, either 4+5 or 6+7. So thats out of bounds because the G3 needs max current from 5 +6. You might want to use either the G3 or the Whammy with its supplied adapter on the courtesy outlet of your PP2+, the other on 5 and/or 6, then you have plenty of room for other stuff. Or, you could get a PP 4x4 or something. Hope that helps.