PP2+ w/ Sennheiser Wireless

[foomanfat]

Is there a way to power a Sennheiser ew172 G2 wireless system with a PP2+?
Thanks

[JohnClark]

I am not sure... It may work from output output 1-4 switched away from normal if it requires less than 100mA (probably unlikely) or perhaps outputs 5 or 6 switched away from normal if it requires less than 250mA. Sennheiser says that the receiver power requirement is "10,5 - 16 V DC battery AA (Mignon)" which does not really tell the whole story. Does the receiver have a power supply for it? If so, what are the output specs listed on the power supply itself?

[foomanfat]

The wireless requires 12v, but 300mA.

[JohnClark]

Where did this info come from? If that is what the output of the power supply is then it is not really the requirement but a working scenario. The stated requirement is "10,5 - 16 V DC" as specified in the manual. Unfortunately there is no current draw mentioned.

What does all this mean?... It likely means that you can use output 5 or 6 with the DIP switch away from Normal. Try it out and let us know what you find. Be sure to find, and mind, the correct polarity for the pedal!