GCX Worksheet

Q & A for building and interfacing your rack gear with Ground Control Pro and GCX-based systems.
Post Reply
Christoffer.N
Posts: 9
Joined: Tue Jun 14, 2016 9:43 am

GCX Worksheet

Post by Christoffer.N »

Hi! I need confirmation on my Worksheet as you can see below
Current I follow the (Pedals, FX Loop, 3 Channel Amp Switching) worksheet.

Now i wanna switch between my 2 amps, the JC-120 and my Boogie!

I followed the A/B switching example 2 from the manual, but the manual also say:

Important: GCX audio loops are for instrument and line level signals only. Using them to switch amplifier or speaker outputs will severely damage your GCX.!???

Regards Chris!
Attachments
test.jpg
test.jpg (24.67 KiB) Viewed 2339 times

JohnClark
Posts: 7494
Joined: Tue May 05, 2009 2:33 pm
Location: The Lab

Re: GCX Worksheet

Post by JohnClark »

Looks good to me!


The warning you mention is saying to never run the Speaker Output of an amp into the GCX. You have Loop 4 selecting which amplifier will receive the guitar signal, no problems there.

I hope that helps!
------------------====Cheers!====------------------
Image
---------==Voodoo Lab Magician & Tech==---------

Post Reply