Hey there. im stuck in a bit of a situation. I'm wanting to go stereo from mono. here are my pedals
Dyan comp
Super overdrive
Distorion III
Line Driver
Pitch shift
Eventide
Lexicon rack
Basically im wanting my eventide and lex to go stereo(both amps). Now i see there is a worksheet on the site that goes mono mono stereo but.... i dont need to go into the FX loop of both amps. there no need for the way i play. i'm thinking of leaving the line driver out the loops and just leaving it on which is what i do anyways.
I use Vox and the left and and orange on the right.
Can anyone help me with wiring. i seem to have hit a dead end or not enough loops.
Is the pitch shift one of the stereo devices? Do all your stereo devices have stereo ins and outs? Is the Line Driver the only thing that will be on at all times?
Im using the pitch mono in mono out in one of the loops. the eventide and the lexi are both stereo in and stereo out. the line driver will be on all the time.
In this case you could use GCX Loops 1, 2, 5, and 6 for your mono pedals. The Out of GCX Loop 6 would feed the line driver and from the output of the line driver you would want to use a Y cable to feed the inputs on GCX Loops 3 & 7. Much like the Mono Mono Stereo drawing, you would run your stereo pedals using GCX Loops 3 & 7 and 4 & 8. The Out jacks of GCX Loops 4 & 8 would feed the inputs of your two amplifiers.
